1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 318Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 318

30 C0A2439 bQuickly clamp the piston tightly in soft-jaw viseUsing breaker bar or sim ilar tool through the eyelet, unscrew
and back-up ring from the end capDiscard the a-ring eOil and install new a-ring and back-up ring in the end cap The square
back-up ring goes above the a-ringfUse heat lamp or hot water to warm new scraperInstall the scraper in the end cap with
the lip facing upgSecure the eyelet end of the rod in soft-jaw vise Using OMC Tilt Cylinder Seal Protector, PIN 326005, slide
the end cap onto the rod in the direction shownPlace new outside a-ring on the end caphSpray the threads of the rod and the
internal threads of the piston with OMC Locquic PrimerIn soft-jaw vise, secure the piston firmly with the smaller valve holes