1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 325Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 325

2Oil and install both trim caps on the trim rods, as shown [] 3Reinstall the manifold in the holding fixtureOil and install
when you are finished[] 6Oil and install both trim end caps in the manifoldThread them in flush with the manifold by handUsing
OMC Trim Cylinder End Cap Remover, PIN 324958, and torque wrench, tighten the end caps to torque of 55-60 ftIbs(75-81 Nm)
7Install the two identical short check valves in the front of the manifoldTighten the valves to torque of 50-60 inIbs(5,5-7,0
Nm), using drag link socket and torque wrench8Install the longer trimtilt separation valve in the port lower side of the
manifoldTighten the valve to torque of 50-60 inIbs(5,5-7,0 Nm) [] 9Oil and install the pump control piston in the position
shownInstall spring on each end of the piston and make sure both springs stay in position correctly when inserting the valve