1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 33Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 33

Break-In Procedure During the first 10 hours of break-in operation you must use 50:1 fueloil ratio in your fuel tank in Oil
for steady stream of water at the water pump indicatorNext 50 Minutes DO NOT operate engine above half throttle (no more
than 3500 RPM) DO NOT hold constant throttle settingChange engine speed every 15 minutesWith easy planing boats, use full
throttle to quickly accelerate boat onto planeImmediately reduce throttle to one-half as soon as boat is on planeBE SURE
boat remains on plane at this throttle settingSecond Hour Use full throttle to accelerate boat onto plane, then reduce throttle
setting to three-quartersBE SURE boat remains on plane at this throttle setting At intervals, apply full throttle for periods
of one to two minutes, returning to three-quarters throttle for cooling period Change engine speed every 15 minutesINotel
Verify water pump operation by looking for steady stream .of water at the water pump indicatorNext Eight Hours Avoid continuous