1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 43Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 43

Synchronization and Linkage Adjustments130 It is important that this step-by-step procedure be followed in sequence and be
until it contacts the No.1 pistonLock the tool in place with ring DR1233 4While holding the flywheel firmly against the tool,
mark the flywheel directly across from the pointerConsider this mark "A"5Continue to turn the flywheel in clockwise direction
until piston contact is felt againMark this exact spot on the flywheel and consider this mark "B"Remove the piston stop tool
6Use flexible scale along the flywheel edge and measure the midpoint between marks "A" and "B"Mark the midpoint on the rim
of the flywheelConsider this mark "C"If the mark "c" and the cast-in TDC line are in agreement, the timing pointer alignment