1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 53Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 53

Synchronization and Linkage Adjustments 125WT, V6, It is important that this step-by-step procedure be followed in sequence
against the tool, mark the flywheel directly across from the pointerConsider this mark rv 5Continue to turn felt againMarka
this exactdirection until the flywheel in clockwise piston contact is spot on the flywheel and consider this mark "B"Remove
the piston stop toolf116Use flexible scale along the flywheel edge and measure the midpoint between marks "A" and "B"Mark
the midpoint on the rim ofthe flywheelConsider this mark "C".lfthe mark "c" and the cast-in TOC line are in agreement, the
timing pointer alignment is correctIf not, proceed to Step 7 7Turn the flywheel to align the mark "c" with the pointerHold
the flywheel in this positionLoosen the pointer screw and move the pointer to align with the cast-in TOC mark on the flywheelTighten