1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 54Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 54

Throttle Plate Synchronization Note Apply light pressure to throttle plates during this procedure to make sure they close
V8Seat all throttle platesTighten throttle shaft connector screwsCD in reverse order6Turn in carburetor link stop screw until
the throttle plates on the port carburetors begin to openThen, back out stop screw enough to close the throttle platesW W
7Carefully tighten both carburetor link adjustment screws while holding ends of carburetor link against stop screw 8Remove
the air silencerVerify operation ofthrottle valvesPort and starboard carburetor throttle valves must open at the same time9If