1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 64Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 64

Preliminarv Adjustments 1Turn the ignition stop switch knob fully counterclockwise f51 2Turn the throttle arm stop screw
is still loose1sl 2While holding the cam follower against throttle cambegin to adjust the throttle arm stop screw until the
cam and the cam follower are touching at bisect point Ml on the throttle cam1sl 3When the throttle arm stop screw is properly
adjusted and the cam and the cam follower are touching at the bisect point, tighten the cam follower screw Q)Do not readjust
the throttle arm stop screw after this stepThere must be 0.005 in(0,13 mm) clearance between the throttle cam and cam follower
to ensure that all throttle plates are closed at idleWide Open Throttle Stop f61 1With the engine not running, twist the
throttle grip to move the throttle arm toward wide open throttle position Loosen locknut Adjust wide open throttle stop screw