1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 70Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 70

Shift Cable 1Extend shift cable and lubricate with OMC Triple-Guard grease2Verify that the fast idle lever is down in the
cable to allow the adjustment in Step 7, or ifthe gearcase detent does not correspond with remote control NEUTRAL in Step
10, refer to Section for shift rod height adjustment i and washer supplied with engineTighten locknut 11Attach shift cable
to shift lever pin using locknut securelyWhen installing OMC Accessory Controls, except for prewired surface mount, the shift
cable must be adjusted and installed when the control and engine are in NEUTRAl12Slip rubber grommet onto control cables
and press grommet into groove in lower engine cover i attached to the proper engine levers by lifting the fast idle lever
to the START positionIf correctly attached, the throttle cable and engine throttle lever will moveWhen installing remote
control that is not manufactured by Outboard Marine Corporation, you must verify that the shift cable stroke is compatible