1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 75Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 75

Heli-Coillnserts and Installers LJ threadsThe installation kit consists of drill, tap, and insertion r:;l Use these Heli-Coil
14 mm (12 inReach) PCE0027 391436 391438 391439 391440 391441 391450 984963 391437 391448 391447 391446 391445 391444 391449
913412 391443 391442 Installation Instructions 1Drill to adequate depth using drill size supplied with kit2Use Heli-Coil
tap supplied with packCheck thread size on shank to make certain proper size is used3Screw insert onto mandrel until tang
is fully engaged in driving contour4Screw insert into tapped holeTop of insert must be onequarter to one-half turn below
top surface5The tang must be removed to allow full passage of screw into the insertThe tang may be broken off cleanly at
the notch in the bottom coil with punch or rod having diameter that just fits into the assembled insertMake sure that the