1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 87Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 87

6Test the "no oil" warning circuit: Connect shop tank with 50: fueloil mix to the fuel inlet fitting Remove the protective
lineInstall the oil hose on the oil inlet fittingUse only the clamp supplied with the kit to secure the line Finish priming
the system by squeezing the oil primer bulb two more times During the break-in period, the engine's fuel tank must have 50:1
fueloil mixture in addition to operation Prime the oil system before priming fuel systemIf fuel system is primed first, the
oil system must be primed with the engine idlingWarning horn will sound until oil reaches pumpthe 8Store the protective cap
removed from the oil inlet fitting on the yellow cap holder attached to the VRO fuel hose(s)9The oil level must be marked
on the side of the reservoir before putting the engine into service After the break-in period, the operator must verify that