1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 91Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 91

Install and secure 10-in(25 cm) length of 14 in(6,35 mm) 1.0clear vinyl hoseA few inches from the loose end, measure carefully,
pulses V6, VBAt 800 RPM, the oil level in your hose should drop in(25,4 mm) in approximately seven pulses All ModelsAt full
throttle, the oil level in your hose should drop in(25,4 mm) in approximately three pulses 7If your results vary, check the
pulse limiter fitting before replacing the pump8If you remove the pump, carefully cut the hose to avoid damaging the fittingWhen
installing, use ratchet clamp on the oil supply hoseTorque the screws, pump-to-bracket, to 18-24 inIbs(2-3 Nm)Refer to Hose