1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 99Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 99

With lever in run position fitting no fluid should enter inlet With lever in prime positionfluid should come out both outlet
fuel tank hose to motor and squeezing primer bulb until definite pressure is felt in the bulb Fuel Enrichment Switch ServicingVB
Function Test 1Remove the vacuum hose, and disconnect the switch from the engine wiring harness 2Connect gearcase vacuum
tester to vacuum hose nipple on the switch 3Calibrate an ohmmeter on appropriate scaleConnect the ohmmeter between terminals
of the switch If ohmmeter shows continuity, replace switch OJ 4Slowly draw vacuum on the vacuum switch hoseThe ohmmeter should
show continuity as the vacuum approaches the switch preset limitRefer to the chart belowLimit (inHg) 5If the ohmmeter does