1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 104Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 104

Assembly 1Install calibration pocket gasket and cover, and torque screws to 10-15 inIbs(1,1-1,7 Nm)2Install slow speed needle
clip must face chamber's port sideInstall float assemblyTighten hinge pin retaining screw securely 8Adjust float height with
chamber invertedFloat must be level with gasket surface, 132 in(0,8 mm)If adjustment is required, do not put pressure on
float valve and seat9Install high speed fuel orifice with OMC Driver, PI 317002, and install float chamber plugTorque plug
to 30-35 inIbs(3-4 Nm) 10Install float chamber and retaining screwsBack out screws in their holes to engage original threadsTorque