1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 149Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 149

Output Tests125WT, 130 & All cranking output tests must be performed with spark plugs installed and torqued in the cylinder
cranking tests 3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump
each tester gap alternately If tester shows good output on all cylinders, go to STEPRUNNING OUTPUT TEST If tester shows good
output on at least one cyli nder, go to STEPSENSOR COIL TEST If tester shows no output, go to STEPSTOP CIRCUIT TEST4Refer
to Troubleshooting Sequence Chart Page 3-28Start with your specific fault symptom and continue troubleshooting in sequence
INote It is possible for the ignition system to have problem but still produce good outputIf the engine "pops" or "backfires"