1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 157Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 157

STEPRUNNING OUTPUT TEST 1Twist and remove all primary leads from ignition coils 2Use clockwise twist to install terminal
5Connect voltmeter red lead to No.1 terminal extenderConnect meter black lead to clean engine ground 6Start engine and run
under load at RPM where ignition problem exists Meter must show 180 volts or higher 7Repeat Steps and for remaining cylinders
If one or more cylinders show low output, go to STEPCHARGE COIL TEST If one or more cylinders show no output, go to STEPSENSOR