1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 164Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 164

STEPCHARGE COIL TEST Ground Test f811Disconnect the stator's forward (cylinders 1, 3, 5) and rear (cylinders 2, 4, 6) 2-pin
rear 2-pin connector5If no reading is indicated in Steps or 4, go to Output TestOutput Test 1Set peak-reading voltmeter to
"POS" and "500"19l2Attach voltmeter black lead to the stator's forward connector, terminal" A"Attach meter red lead to terminal
"B"3Crank engine and observe meter If meter shows 130 volts or higher, go to STEPSENSOR COIL TEST If meter shows less than
130 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter Test4Repeat