1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 166Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 166

12 OR4061 STEPSENSOR COIL TEST Ground Test 1Oisconnect the two 4-pin Amphenol connectors between the timer base and power
"A", "B", and "C", and port connector, terminals "A", "B", and "C"3Crank engine and observe meter at each connection If meter
shows 0.2 volt or higher, go to Step If meter shows less than 0.2 volt, check condition of wiring and connectors If wiring
and connector condition is good, go to Ohmmeter Test4Connect the "0" terminals in the separated port timer base connector
using jumper wire Connect the "0" terminals in the separated starboard timer base connector using jumper ire 5Attach the
voltmeter black lead to clean engine groundAttach meter red lead alternately to starboard connector, terminals "A", "B",
and "C", and port connector, terminals "A", "B", and "C"6Crank engine and observe meter at each connection If meter shows