1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 167Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 167

Sensor Coil Ohmmeter Test INote All running ohmmeter tests must be performed with engine not 1Before proceeding, you must
M-700 meter: 970 100 ohms Fluke 29 Series II meter: 975 100 ohms INote The Fluke 29 Series II meter must be set to the low
ohms (40 0) scale for this testRead the operating instructions that came with the meter Ohmmeter readings will vary with
individual meter impedanceYour readings might be slightly higher or lower, but should all be approximately equal 5Attach
ohmmeter red lead to port timer base connector, terminal "0"Attach meter black lead to starboard timer base connector, terminal
"0" Meter should read 230 30 ohms 6To test for grounded condition, connect ohmmeter alternately between each port and starboard
terminal location and clean engine ground Meter must show high reading If meter shows low reading, locate and repair ground