1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 169Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 169

STEPRUNNING OUTPUT TEST 1Twist and remove all primary leads from ignition coils.atwist to install terminal extenders, Stevens
voltmeter red lead to No.1 terminal extenderConnect meter black lead to clean engine ground6Start engine and run under load
at RPM where ignition problem exists Meter must show 130 volts or higher7Repeat Steps and for remaining cylinders If one
or more cylinders show low output, go to STEPCHARGE COIL TEST If one or more cylinders show no output, go to STEPSENSOR COIL