1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 171Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 171

Output Tests ill "" All cranking output tests must be performed with spark plugs installed and torqued in the cylinder headIf
jump each tester gap alternately If tester shows good output on all cylinders, go to STEPRUNNING OUTPUT TEST If tester shows
no output on cylinders thru 8, go to STEPSHIFT SWITCH TEST If tester shows good output on at least one cylinder, go to STEPCHARGE
COIL TEST If tester shows no output, go to STEPSTOP CIRCUIT TEST4Refer to Troubleshooting Sequence Chart Page 3-50Start with
your specific fault symptom and continue troubleshooting in sequence IN=J It is possible for the ignition system to have
problem but Coil primary wire routing Spark plug lead routing Flywheel condition and location Synchronization and linkage