1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 176Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 176

8 STEPCHARGE COIL TEST Ground Test 1sl1Disconnect the stator's forward (cylinders thru 8) and rear (cylinders thru 4) 2-pin
rear 2-pin connector5If no reading is indicated in Steps or 4, go to Output TestOutput Test 1Set peak-reading voltmeter to
"POS" and "500" EI terminal "B" Inlg 2Attach voltmeter black lead to stator's forward connector, terminal "A"Attach meter
red lead to 3Crank engine and observe meter If meter shows 130 volts or higher, go to STEPSENSOR COIL TEST If meter shows
less than 130 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter Test4Repeat