1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 183Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 183

Output Tests125RW i plugs installed and torqued in the cylinder headIf necessary to remove the spark plugs, be sure to keep
shock hazard, do not handle ignition coils 3If equipped, install the emergency stop switch clip and lanyard assemblyCrank
the engineSpark should jump each tester gap alternately If tester shows good output on all cylinders, go to STEPRUNNING OUTPUT
TEST If tester shows good output on at least one cylinder, go to STEPSENSOR COIL TEST If tester shows no output, go to STEPSTOP
CIRCUIT TEST4Refer to Troubleshooting Sequence Chart Page 3-62Start with your specific fault symptom and continue troubleshooting
in sequence rN=J It is possible for the ignition system to have problem but still produce good outputIf the engine "pops"