1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 190Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 190

STEPPOWER PACK TEST To prevent accidental starting of engine while testing, twist and remove all spark plug leads 1Twist
"POS" and "500" 4Connect voltmeter red lead to adapter red lead and meter black lead to clean engine ground 5Crank engine
and observe meter Meter must show 150 volts or higher 6Repeat Steps thru for remaining ignition coil primary leads If all
primary leads have good output, test ignition coilsRefer tolgnition Coil Tests, Page 3-10 If one primary lead has no output,
replace power packRefer to Ignition Component Replacement, Page 3-18 7Remove load adapter and install ignition coil primary