1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 191Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 191

14 DR4053 STEPRUNNING OUTPUT TEST 1Twist and remove all primary leads from ignition coils.aclock":'Visetwist to install terminal
voltmeter to "POS" and "500"11415C.onnect voltmeter red lead to No.1 terminal extenderConnect meter black lead to clean engine
ground6Start engine and run under load at RPM where ignition problem exists Meter must show 180 volts or higher7Repeat Steps
and for remaining cylinders If one or more cylinders show low output, go to STEPCHARGE COIL TEST If one or more cylinders