1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 206Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 206

Cleaning Before inspecting or assembling powerhead, all internal components must be perfectly clean and free of contaminants1Remove
when using OMC Gel Seal and Gasket Remover 12814Use OMC Gel Seal and Gasket Remover to remove all traces of gaskets, adhesives,
and Gel-Sealllfrom the cylinder block and crankcase 5Carefully remove any carbon accumulation from the tops and ring grooves
of the piston ring groove cleaning tool can be made by breaking an old ring and grinding its end to an angleDo not damage
ring grooves while cleaning6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all traces
of contaminants7Air dry cylinder block and crankcaseBlowout all holes and passageways with compressed air To avoid personal