1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 207Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 207

Inspection 1Before any inspection process can begin, all internal components must be clean and free of excess oil 2Make visual
rings in their original positions on crankshaft after inspection 32 6Use telescoping gauge or inside-reading micrometer to
33 7Measure each cylinder in at least two areas as shown Each The cylinder must not be out-of-round by more than 0.004 in(0,10
mm) inspect each cylinder bore for an out-of-round, oversize, or tapered condition Be sure the gauge or micrometer is perfectly
square in the bore when measuring area should be measured twiceThe difference between the two measurements in each area is
the cylinder out-of-round dimension dimensional difference between the two areas is c ylmder taper The cylinder taper must
not exceed 0.002 in (0,05 mm) 33 9The difference between your measurements and standard bore dimension is cylinder oversizeRefer
to Engine SpecificationsSection 1, for dimensions The cylinder must not be oversize by more han 0.004 in(0,10 mm)If any cylinder