1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 209Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 209

Assemblv Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly
bearing until it seats in the crankshaftr:;l4V4, V6To install new crankshaft sleeve: Oil the end of the crankshaftPlace the
sleeve in OMC Crankshaft Bearingl Sleeve Installer, PIN 338649, and drive the sleeve onto the crankshaft until the installer
contacts the lower main bearing If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PIN 391008,
into installer and pull offInspect sleeve surface after installingSleeve must not be used if surface is damaged5V4, V6Lubricate
new driveshaft a-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall a-ring in sleever;;] 6vaTo install