1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 210Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 210

[] 7Using retaining ring pliers, install lower main bearing retaining ring with sharp edge of ring facing out rn 8Lightly
inIbs(11-14 retainer and 12Lightly coat the outside diameter of new seal with OMC Gasket Sealing CompoundUse flat tool to
install seal flush in upper crankcase head, lip facing downCoat the seal lip with OMC Triple-Guard grease 13Lightly coat
two new O-rings with OMC Triple-Guard grease, and install on upper crankcase head 14It is very important to notice that there
are port and starboard pistons in this engineAll pistons are also marked "exhaust side" Using these marks, orient the pistons
with the correct cylinders and mark the bottom wrist pin hole with an indelible marker15It is also very important to notice