1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 212Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 212

[1ID 1201 22 When all pistons and connecting rods are assembled, install piston ring setsInstall each piston ring set on
piston rings on their dowel pinsSlide No.2 piston assembly into top cylinder, as shown, while guiding connecting rod through
cylinder block26Repeat Steps 24 and 25 for remaining piston(s) on the port side27Lightly coat both sides of new cylinder
head gasket with OMC Gasket Sealing Compound V4, V6Position gasket on cylinder block following instructions printed on gasket
122! 25Center connecting vaPosition gasket on cylinder block with tab facing up 28Install port cylinder head, thermostat
facing flywheel, and install retaining screwsFollowing sequence on cylinder head, torque all screws in stages to: V4, 18-20
ftIbs(24-27 Nm) V615-17 ftIbs(20-23 Nm) 29Rotate cylinder block so that starboard cylinder head surface is parallel with
floor30Repeat Steps 24 and 25 for the starboard cylinders 31Rotate cylinder block so that crankcase mating flange is facing