1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 217Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 217

Installation [] 1Install new base gasketwithout sealerThe gasket has coating which is heat activated and must be assembled
Nm)INote In order to achieve proper sealing and prevent gasket damage, the powerhead mounting screws must be retorqued after
engine has reached operating temperature and has been allowed to cool Torque the powerhead to adaptor screws and nuts to
144-168 inIbs(16-19 Nm) 7If equipped with power steering, install the system Apply OMC Nut Lock to threads of reservoir-to-cylinder-block
screwsTorque the reservoir-to-cylinder-block screws to 18-20 ftIbs(25-27 Nm)Route all hoses and secure in their original
locations8Thoroughly clean the crankshaft and flywheel tapers with OMC Cleaning Solvent and let air dry9Install flywheel
key in crankshaft with flat side parallel to crankshaft centerline[] 10Align the crankshaft key and flywheel keyway and install