1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 230Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 230

40 COA1373 40Using OMCRope Threading Tool, PIN 378774, thread the rope through the starter handle ITII 41Place the starter
grease Place the thicker flat washer Place lower lockout lever Place two springs on shaft on shaft on shaft Place upper lockout
lever on shaft Place the thinner flat washer on shaft& Install locknutReplace locknut if you do not feel definite resistance
to tightening Torque locknut to 60-84 inIbs(7-9 Nm) 1 45Verify location of lockout springs44 1451 46Inspect the rope guide