1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 253Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 253

fJ17If required, remove the screws, stern bracket to trim manifold, and remove the trim and tilt unit V6, va ModelsRemove
in the swivel bracketBoth seal lips face out Coat seal's outside diameter with OMC Gasket Sealing Compound Coat the bushing
and seal lips with OMC Triple-Guard grease8 19l2Install the trim and tilt unitApply OMC Locquic Primer and OMC Nut Lock to
the threads of screws, stern bracket to trim manifoldInstall them loosely V6, va Models -Install the tilt cylinder thrust
rodReplace the locknuts if definite resistance to tightening is not feltr;Ql 3Coat two tilt tube bushings with OMC Triple-Guard