1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 262Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 262

1.J5l10If removed, install new inner exhaust housing sealApply OMC Adhesive to the seal groover;Gl11Clean and degrease the
the ground lead and star washer under the forward starboard screw 14Apply Locquic Primer and OMC Nut Lock to the upper r:J8l15Align
the outer exhaust housing and adapter by placing two powerhead mounting screws through their holes11 916Torque the four mount
plate screws to 22-24 ftIbs(30-33 Nm) 120) 17Torque the small adapter to exhaust housing screws to 60-84 in Ibs(7-9 Nm)18If
removed, coat the lower mounts with soapy water and press into the exhaust housingNotice one side is identified "OUT i and
torque them to 150-180 inIbs(17-20 Nm) 19Install the lower mount coversInstall the screws Replace any lock patch screw if