1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 274Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 274

Propeller InstallationAll Models INote These instructions apply when spacer is brassIf spacer is made of nylon, replace with
on propeller shaft by aligning splines and pushing until it seats on the thrust bushing rn 7Wedge aplateof wood between propeller
blade and the block anti-ventilation [I] rn 8Install the propeller nut and tighten to 70-80 ftIbs(95-105 Nm)OJ rn 9Position
keeper on propeller nut with one space between tabs aligned with cotter pin hole in propeller shaftler nut to achieve alignmentDo
not loosen OJ 6Install the spacerengaging the propeller shaft splines INote If keeper will not align with cotter pin hole,