1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 276Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 276

5Install the water tube grommet facing up with the inside taper [[] 6Install the impeller housing cover [[] 7Apply OMC Adhesive
Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading edge during driveshaft
rotation 4Slide the water pump assembly down the driveshaftAlign slot in the impeller with the impeller cam Rotate the driveshaft
to engage the impeller cam with the impeller, and slide water pump assembly down over impellerBe sure impeller cam does not
fall out of position INote Verify that the impeller engages the impeller cam properlySerious powerhead damage will result
if impeller cam is displaced5Align the impeller housing with the gearcaseApply OMC Gasket Sealing Compound to threads of