1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 282Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 282

5Remove the large thrust washerthrust bearingand reverse gear from the gearcase [] 6Remove the small thrust washer from either
the handle of the holder to prevent damage to the gearcase[]]10Pull up on the driveshaft to remove it from the gearcaseThe
driveshaft to pinion taper is locking taperIf necessary, use OMC Puller, PI 390706 Q), and OMC Backing Plate, PIN 325867to
break the lockInstall the tools as shown by clamping them around the driveshaft with the toolset screw aligned with the water
pump drive cam slotThen, tighten the set screw into the slotAlternately tighten the two vertical screws against the backing