1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 283Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 283

COA3149 12Reach inside the gearcase and remove the pinion and pinion nutRemove any loose needle bearings that might interfere
under one end of the clutch dog spring and remove it from the groove by unwrapping it from around the clutch dog Discard
the spring16Push the pin out of the clutch dogThe bearing housing assembly will now pullout of the end of the propeller shaft,
and the clutch dog will slide off the splines 17Pull the forward gearthrust bearingand thrust washer off the bearing housing18Push