1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 285Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 285

Propeller Shaft Bearing Housing Service 1Remove the seal using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws,
the jaws securely behind the bearing 3Discard the bearing housing O-ringClean the housing and bearings in solvent, and dry
thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring
groove; sand off any sharp edges that would cut O-ring and prevent its sealing]] 4Inspect the bearing housing anodeReplace
anode if it has eroded to two-thirds its original size (one-third eroded) m rn 5.Bearing Installer,newNbearings intothe bearing