1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 286Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 286

[] 6Install new seal in rear of the bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal before
bearing housing seal using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the seal2Remove the
a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and
the -ring grooveDR5720 rn 4Install a341439Apply oil to casing of the seal before new seal in the bearing housing using OMC
Seal Installer, PIN installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard grease
to the seal lips after installing 5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove of