1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 290Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 290

7Lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing,
pin 11Push the detent lever down to its most depressed positionRest the cradle on the shift shaft then attach the cradle
and shaft to the wide arms of the shifterPull the detent lever back up to NEUTRAL position to hold the cradle and shaft in
place12Coat thrust bearing and thrust washer with OMC Needle Bearing Assembly GreasePlace the bearing on the back of the
forward gearSet the washer on top of the thrust bearingInsert the gear, bearing, and washer assembly into the bearing housingBe
careful not to dislodge any of the loose needle bearings INotel Bearing shown and washer must be installed exactly as 13Align
holes in the clutch dog with slot in the propeller shaftInstall the clutch dog on the shaft with "PROP END" facing rear of