1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 292Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 292

20Apply OMC Gasket Sealing Compound to the threads of the shift rod cover screwsInstall the screwsTighten the screws to 60-84
removed from the pinion needle bearingsDegrease inside taper of the pinionPosition the pinion in the gearcase25Degrease the
driveshaft taper and install the driveshaft26lightly coat the threads of the pinion nut with outboard lubricant and install
on the driveshaftTurn the driveshaft by hand to engage the nut27Turn the gearcase right side upUsing OMC Driveshaft Socket,
PIN 311875, and OMC Pinion Nut Holder, PI 334455, tighten the pinion nut to 70-80 ftIbs(90-108 Nm) INote Over-tightening
or under-tightening the pinion nut will reduce pinion lifeDo not reuse damaged pinion nuts 28Position the washers on the
driveshaft bearing housing screwsApply OMC Gasket Sealing Compound to the threads of the screwsInstall and tighten screws