1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 294Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 294

33Before installing lubricant, pressure test and vacuum test the gearcase as follows: Remove the oil level plug, and screw
lubricant 1271 12s1 34Fill the gearcase with lubricant as follows: Secure the gearcase in an upright position Remove the
oil level plug and the drainfill plugReplace their seals, if damaged Fill the gearcase with OMC Ultra-HPF gearcase lube until
it appears at the oil level holeInstall the oil level plug, then the drainfill plugTighten them to 84-86 in Ibs(9-10 Nm)
Check the oil level after the motor has been run 1291 35Adjust the shift rod as follows : Check the shift rod height from
the shift rod hole to the surface of the gearcase using OMC Universal Shift Rod Height Gauge, PIN 389997 With the shift rod
in NEUTRAL and the offset facing forward, rotate the shift rod full turns up or down as necessary for correct adjustment66
Shaft Length 20 in(508 mm) 22112 in(571 mm) 25 in(635 mm) 30 in(762 mm) 21 15116 1 32 in557,3 0,8 mm 24 7 16 132 in620,7