1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 295Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 295

Installation 1Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may
crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position [[] gearcaseApply
OMCscrewsInstall the screws and threads as rn 5retaining Gasket Sealing Compound to tighten of the follows: inscrews: 26-28
ftIbs(35-38 Nm) inscrews: 45-50 ftIbs(61-68 Nm) 6Apply OMC Gasket Sealing Compound to threads of the trim tab screwInstall
the trim tab and align it with the index marksTighten the screw to 35-40 ftIbs(47-54 Nm) 7Engage the shift rod in the shift