1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 300Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 300

112l5Remove the large thrust washerthrust bearingand reverse gear from the gearcaseRemove the small thrust washer, forward
from the gearcaseThe driveshaft to pinion taper is locking taperIf necessary, use OMC Puller, PIN 390706and OMC Backing Plate,
PIN 325867 CD, to break the lockInstall the tools as shown by clamping them around the driveshaft with the tool's set screw
aligned with the water pump drive cam slotThen, tighten the set screw into the slotAlternately tighten the two vertical screws
against the backing plate inserted between the puller and the gearcase until the driveshaft pops loose from the pinion, then