1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 302Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 302

20The detent ball and spring can come out with great forceWear safety glasses for eye protectionPut shop cloth around the
the pinion bearing only if it needs to be replacedRemove the retaining screwDiscard the O-ring from the screw24If the driveshaft
bearing must be replaced, use OMC Bearing Remover and Installer, PI 391257, and assemble it as follows: CD Flange Nut, PIN
326586 (MJ Plate, PI 391260 Rod, PIN 326582 Remover, PIN 326579 Note Make sure all 19 needle bearings are inside bearing
case before pulling bearingThe needle bearings will provide surface for the remover tool to pull againstTurn nut and pull