1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 303Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 303

25If the water intake screen cannot be unplugged by cleaning, replace it: Remove screw on starboard side of gearcase above
securely behind the seal INotellnspect bearings in placeIf bearing is removed for any reason, it must be discarded 2Remove
either bearing using OMC Puller Bridge, PI 432127, and OMC Large Puller Jaws, PIN 432129Rest the puller plate on top of the
housing to support the bridge, and tighten the jaws securely behind the bearing3Discard the bearing housing O-ringClean the
housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to
check for freedom of movementInspect O-ring groove, and sand off any sharp edges that would cut O-ring and prevent its sealing
4Oil, then install new bearings in the bearing housing: Use OMC Bearing Installer, PIN 339750, to install the front bearing