1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 304Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 304

[]] 5Install new seal in rear of the bearing housing using OMC Seal Installer, PIN 341439Apply oil to casing of the seal
the driveshaft bearing housing seal using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard the
seal 2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from
the seal bore and the a-ring groove[] 4Install new seal in the bearing housing using OMC Seal Installer, PIN 341439Apply
oil to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OMC Triple-Guard
grease to the seal lips after installing]5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove