1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 307Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 307

5Rotate the driveshaft several revolutions to seat bearings f41 6Position the correct shim gauge against guide pins of the
and the pinion with feeler gauge 0)Replace the pinion or the driveshaft, as necessary, and repeat the check if variance exceeds
0.002 in(0,050 mm) 9Subtract the average clearance measurement obtained in Step from 0.030 in(0,762 mm) to determine the
correct shim thickness requiredSelect the fewest number of shims to achieve the correct thickness10Remove the driveshaft
from the tool baseRemove the collar and bearing housing from the driveshaft and add the required amount of shimsUse extreme
care when removing bearing housing to avoid damaging the sealsUse OMC Driveshaft Seal Protector, PIN 31867411Check shimming
by reassembling the driveshaft with shims and placing it back into the tool baseYour reading between the gauge bar and the