1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 309Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 309

filSTo begin the reassembly ofthe shift mechanism, apply OMC Needle Bearing Assembly Grease to the detent ball and springInsert
Assembly Grease to the thrust bearing and thrust washerInstall the thrust bearing on shoulder of the forward gearInstall
the thrust washer on shoulder of the bearing housingPlace the forward gear into the bearing housingMake sure the thrust bearing
is between the thrust washer and forward gearrJllNotel Bearing shown and washer must be installed exactly as 1al14Align holes
in the clutch dog with slot in the propeller shaftInstall the clutch dog on the shaft with "PROP END" facing rear of the
shaftThe clutch dog is not symmetricalIf installed backward, it will not fully engage reverse gear and will immediately damage
itself and the gear19l15Slide the propeller shaft onto the shifter shaft and align the hole in the shaft with the hole in