1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 311Get this manual

1995 Johnson/Evinrude Outboards 125-300 90 degree LV Service Manual, Page 311

r,&l r:J7l22 Lightly apply OMC Gasket Compound to the gearcase area that contacts mountmg flange of the bearing housingDo
torque the pinion nut to 100-110 ftIbs(136-149 Nm) Overtorquing or undertorquing the pinion nut will reduce pinion lifeDo
not reuse damaged pinion nuts r:J9l27Position the washers on the driveshaft bearing housing screwsApply OMC Gasket Sealing
Compound to the threads of the screwsInstall the screws and tighten little at time to press the bearing housing down evenlyTighten
screws to torque of 168-192 inIbs(19-22 Nm)20 washer on the hub of the reverse gearApply OMC Needle Bearing Assembly Grease
to the small thrust washer Place the small thrust washer in recess of the reverse gearSlide the reverse gear onto the propeller
shaft until it engages the pinionr:;::;l29Carefully apply OMC Gasket Sealing Compound to both O-ring flanges of the bearing
housingDo not allow sealer to contact either forward thrust surface or bearings in the housingInstall the housing in the